Introduction to the reasons for the tilt of the spring after full pressure
Release Time:
Dec 21,2023
The steel wire used to make the spring is 1.5, the outer diameter of the spring is 8.1, and the height is 12.3 (13 after full compression, not fully compressed). After a lot of debugging, it can be seen that this may be the residual deformation of the spring. There are four possible reasons:
The steel wire used to make the spring is 1.5, the outer diameter of the spring is 8.1, and the height is 12.3 (13 after full compression, not fully compressed). After a lot of debugging, it can be seen that this may be the residual deformation of the spring. There are four possible reasons:
1. The tensile strength of the spring material does not meet the standard requirements, that is, the steel wire is generally considered to be soft. You can try another batch number.
2. The compression and deformation of the spring exceeds the limit deformation of the spring, that is, the spring cannot be compressed during the design period, and the test deformation can be calculated.
3. Grinding of the end face of the spring results in annealing of the end ring.
4. The spring temperature is too high to check the temperature sensor device and display device.
Key words:
Address: No. 349, Loujia Industrial Zone, Datang Town, Zhuji City, Zhejiang Province, China